Register A Device To The Cisco Webex Cloud Service - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Register a device to the Cisco Webex cloud service

You can register a device to Cisco Webex remotely from the web
interface instead of using the on-screen setup assistant.
To register a device, you need to create an activation code on
Control Hub first. To learn how to create an activation code, see
► Create a Place and Add Services for a Cisco Webex Room
Device or a Cisco Webex Board
From the web interface, you can only register a device that is not
currently registered to a service.
NOTE: All local users and any customizations that have been
created for this device will be deactivated.
D15362.16 DX70 and DX80 Administrator Guide CE9.13, JUNE 2020.
Configuration Peripherals
1. Sign in to the web interface, and click
Webex on the Home screen.
This link is only available if the device is not registered to a
service already.
2. A pop-up appears and you can enter the activation code you
have created on Control Hub.
Format:
• xxxx-xxxx-xxxx-xxxx, or
• xxxxxxxxxxxxxxxx
3. After registration, you must setup the time zone and language
settings from the on-screen setup assistant. If the wizard
times out, default settings will be applied.
Maintenance
Click here to register to
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
214
Administrator Guide
Device settings Appendices Appendices
Limitations
Some of the available configurations only
apply to on-premises registered devices.
They don't apply to Webex registered
devices. In the API guide's Supported
Commands Matrix, these items are
marked with "On-prem only".
Among the non-applicable configurations,
are those related to H.323, H.320, SIP,
NTP, CUCM, LDAP, Proximity, and Far End
Camera Control.