Usermanagement Ldap Minimumtlsversion; Usermanagement Ldap Mode; Usermanagement Ldap Server Address; Usermanagement Ldap Server Port - Cisco Webex DX70 Administrator's Manual

Hide thumbs Also See for Webex DX70:
Table of Contents

Advertisement

Cisco Webex DX70 and DX80
Introduction

UserManagement LDAP MinimumTLSVersion

Set the lowest version of the TLS (Transport Layer Security) protocol that is allowed.
Requires user role: ADMIN
Default value: TLSv1.2
Value space: TLSv1.0/TLSv1.1/TLSv1.2
TLSv1.0: Support TLS version 1.0 or higher.
TLSv1.1: Support TLS version 1.1 or higher.
TLSv1.2: Support TLS version 1.2 or higher.

UserManagement LDAP Mode

The device supports the use of an LDAP (Lightweight Directory Access Protocol) server
as a central place to store and validate usernames and passwords. Use this setting to
configure whether or not to use LDAP authentication. Our implementation is tested for the
Microsoft Active Directory (AD) service.
If you switch on LDAP Mode, make sure to configure the other UserManagement LDAP
settings to suit your setup. Here is a few examples.
Example 1:
- UserManagement LDAP Mode: On
- UserManagement LDAP Address: "192.0.2.20"
- UserManagement LDAP BaseDN: "DC=company, DC=com"
- UserManagement LDAP Admin Group: "CN=admin group, OU=company groups,
DC=company, DC=com"
Example 2:
- UserManagement LDAP Mode: On
- UserManagement LDAP Address: "192.0.2.20"
- UserManagement LDAP BaseDN: "DC=company, DC=com"
- UserManagement LDAP Admin Filter: "(|(memberof=CN=admin group, OU=company
groups, DC=company, DC=com)(sAMAccountName=username))"
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: LDAP authentication is not allowed.
On: LDAP authentication is allowed.
D15362.16 DX70 and DX80 Administrator Guide CE9.13, JUNE 2020.
Configuration
Peripherals
Maintenance

UserManagement LDAP Server Address

Set the IP address or hostname of the LDAP server.
Requires user role: ADMIN
Default value: ""
Value space: String (0..255)
A valid IPv4 address, IPv6 address or hostname.

UserManagement LDAP Server Port

Set the port to connect to the LDAP server on. If set to 0, use the default for the selected
protocol (see the UserManagement LDAP Encryption setting).
Requires user role: ADMIN
Default value: 0
Value space: Integer (0..65535)
The LDAP server port number.

UserManagement LDAP VerifyServerCertificate

When the device connects to an LDAP server, the server will identify itself to the device by
presenting its certificate. Use this setting to determine whether or not the device will verify
the server certificate.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The device will not verify the LDAP server's certificate.
On: The device must verify that the LDAP server's certificate is signed by a trusted
Certificate Authority (CA). The CA must be on the list of trusted CAs that are uploaded to
the device in advance. Use the device's web interface to manage the list of trusted CAs
(see more details in the administrator guide).
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
179
Administrator Guide
Device settings
Device settings
Appendices

Advertisement

Table of Contents
loading

This manual is also suitable for:

Webex dx80

Table of Contents