Installation; Installation Instructions; Inspection; Unpacking - Jackson Conserver XL2 Series Installation, Operation And Service Manual

INSTALLATION

INSPECTION

Do not throw away the
container if damage is
evident!

UNPACKING

LEVELING

PLUMBING

The plumber MUST flush
the incoming water line!
A water hardness test
must be performed.
07610-002-10-23-U
Before installing the
machine
packaging is damaged, the machine might also be damaged. If there is damage to both
the packaging and machine, do not throw away the packaging. The
inspected and packed at the factory and is expected to arrive to you in new, undamaged
condition. However, rough handling by carriers or others might result in damage to the
while in transit. If so, do not return the
machine
contact the carrier and ask them to send a representative to the site to inspect the
damage and complete an inspection report. You must contact the carrier and the dealer
that sold you the within 48 hours of receiving the machine.
machine
While removing the machine from the packaging, ensure that there are no missing
parts. If an item is missing, contact the manufacturer immediately.
The must be level in its operating location to prevent damage to the machine
machine
during operation and to ensure the best results. The machine comes with four adjustable
bullet feet, which can be turned using a pair of channel locks (or by hand if the
can be raised safely). Ensure that the
back before making any connections.
x4
Plumbing connections must comply with all applicable local, state, and national
plumbing codes. The plumber is responsible for ensuring that the incoming water line
is thoroughly flushed before connecting it to any component of the machine. It is very
important to remove all foreign debris from the water line that might potentially get
trapped in the valves or cause an obstruction. Any valves that are fouled as a result of
foreign matter left in the water line—and any expenses resulting from this fouling—are
not the responsibility of the manufacturer.
A water hardness test must be performed to determine if a water treatment system
needs to be installed.
INSTRUCTIONS
, check the packaging and machine for damage. If the
machine
is level from side-to-side and front-to-
machine
has been
machine
to the manufacturer; instead,
machine
8