Instructions; Installation Instructions; Inspection; Unpacking - Jackson DISHSTAR HT-E Installation, Operation And Service Manual

INSTALLATION

INSPECTION

Do not throw away
packaging if damage
is evident!

UNPACKING

PLUMBING

Plumber must flush
incoming water line!
WATER SUPPLY
CONNECTIONS:
WATER HARDNESS
HIGHER THAN 3 GPG
A water hardness test
must be performed.
07610-004-43-79-Q
Before installing machine, check packaging and machine for damage. Damaged
packaging might be an indication of damage to machine. If there is any type of
damage to both packaging and unit, do not throw away the packaging. The machine
has been inspected at the factory before shipping and is expected to arrive in new,
undamaged condition. However, rough handling by carriers or others might result
in damage to machine while in transit. If this occurs, do not return machine to the
manufacturer. Instead, contact the carrier and ask them to send a representative to
the site to inspect the damage and request that an inspection report be completed.
Contact the carrier and dealer within 48 hours of receiving machine.
The machine should be unpacked and removed from pallet before installing. Open front
door and remove all materials from inside. Once unpacked, verify there are no missing
parts. If a part is missing, contact manufacturer immediately.
All plumbing connections must be made to adhere to local, state, territorial, and
national codes. The installing plumber is responsible for ensuring the incoming water
lines are flushed of debris before connecting to machine. Note that chips and materials
from cutting processes can become lodged in the solenoid valves and prevent them
from opening or closing. Any valves that are found to be fouled or defective because
of foreign matter left in the water line, and any subsequent damage, are not the
responsibility of the manufacturer.
See the HT-E Dimensions or HT-E-SEER Dimensions page (depending on your
model) and reference item "B" for water inlet connection location.
The manufacturer does NOT endorse "Tankless On-demand" water heaters
NOTICE
for use with their dishmachines. The manufacturer DOES endorse, and highly
recommends, the standard "Tank" style water heaters, sized to properly handle the
water heating requirements of the facility.
A water hardness test must be performed. If water hardness is higher than 3 GPG and
a water softener is not being used, install an SPS (see Plumbing Options page) into
the water line between the facility water line and machine water line (installed at the
factory). Observe proper inlet/outlet water directions. A water shut-off valve should be
installed before installing the SPS to allow access for service. The water supply must
be capable of a minimum of 10 PSI "flow" pressure at the recommended temperature
indicated on the data plate.
Example
Facility Shut-off Adapter SPS
Water Line Valve

INSTRUCTIONS

Adapter Machine
Water Line
*Adapters needed will vary.
7