Table of Contents
Advertisement
ucnciiHL ma i ruv i ivna (installation)
N0TE:Read the following instructions carefully, Proper installation of your Jackson Dishwasher will assure
proper machine operation.
UNCRATING JV24
1. Remove straps around carton.
2. Open top flaps of dishwasher carton.
3. Remove any packing from top and sides of machine that can be done with ease from top.
4. Slide carton sleeve upward over top of dishwasher, set to one side.
5. Lift dishwasher and wooden base from carton base.
6. Move dishwasher to general installation area.
7. Remove bolts holding wooden base to machine and screw in adjustable feet supplied.
8. Reassemble wash and rinse assemblies in machine using sketch and instructions in this manual.
9. Set dishwasher in place, ready for installation.
NOTE:
NSF base gasket installation must be field installed on all AF and BF models. Gasket goes around
bottom on lower edge of sides, back and kick plate; secure in piece using liquid adhesive.
INSTALLATION INSTRUCTIONS
1. Level dishwasher machine using adjustable feet.
2. Refer to dimensional date sketch for connections.
3. The drain from the machine is a gravity drain system and should, therefore, have the proper drop from the
machine to the kitchen's drain system. The drain connection is locate: to the left rear of the machine when
facing the machine's door. The drain fitting is 1-1. 2" OD tube size. 7" from floor.
4. The incoming water line should be attached to the machine's connection which is located to the front left
sice
the machine. The pipe size to the machine should be 12" anc the water should be 140° for the
ncce E's and 180° for the mode! A's.
5. The e ectrical connections shoulo be made to the terminal board locate: at the left center front. The ter-
-i-a.s are marked LI, L2 and Neutral.
INSTALL PROPER CIRCUIT BREAKER. WIRE AND CONDUIT
SIZE "'CONFORM WITH LOCAL AND OR NATIONAL CODES ;S~-NDARDSv
DIMENSIONAL DATA
Reference only
Subject to change
C^. -CCK
Advertisement
Table of Contents
