Table of Contents
Advertisement
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
VISUAL INSPECTION: Before installing the unit, check the
container and machine for damage. A damaged container is
an indicator that there may be some damage to the machine.
If there is damage to both the container and machine, do not
throw away the container. The dishmachine has been inspect-
ed and packed at the factory and is expected to arrive to you
in new, undamaged condition. However, rough handling by
carriers or others may result in there being damage to the unit
while in transit. If such a situation occurs, do not return the unit
to Jackson; instead, contact the carrier and ask them to send
a representative to the site to inspect the damage to the unit
and to complete an inspection report. You must contact the
carrier within 48 hours of receiving the machine. Also, contact
the dealer through which you purchased the unit.
Packaged unit should be visually inspected for damage.
UNPACKING THE DISHMACHINE: Once the machine has
been removed from the container, ensure that there are no
missing parts from the machine. This may not be obvious at
first. If it is discovered that an item is missing, contact Jackson
immediately to have the missing item shipped to you.
Use a pry bar and mallet to remove the hold-down blocks.
INSTALLATION INSTRUCTIONS
LEVEL THE DISHMACHINE: The dishmachine is designed to
operate while being level. This is important to prevent any
damage to the machine during operation and to ensure the
best results when washing ware. The unit comes with
adjustable bullet feet, which can be turned using a pair of
channel locks or by hand if the unit can be raised safely.
Ensure that the unit is level from side to side and from front to
back before making any connections.
R24/R30 Installation & Operation Manual 07610-002-24-71
Issued: 07-31-2006 Revised: N/A
5
Lift the box off of the unit.
Remove any protective plastic prior to installation.
Lower
Raise
Advertisement
Table of Contents
