Troubleshooting - Husqvarna Soff-Cut 150 E Operator's Manual

Troubleshooting schedule
WARNING: Troubleshooting causes risk of
injury because personnel does work in the
Problem
The product causes chipping/
spalling or ravelling in the cut.
20

Troubleshooting

Solution
Do a check that the blade is not worn out, smooth, out of shape or damaged.
Do a check of the spring pressure. Push the front and rear blade block shafts up.
There must be a low to moderate pressure.
Examine the wheels for damage and make sure that the wheels rotates freely
and smoothly.
Make sure that the skid plate do not touch the blade and moves freely up and
down the full shaft length.
Make sure that the skid plate is not worn out or that there is no distance around
the blade.
Do a check at the bottom of skid plate and make sure there are no metal burrs or
defects.
Make sure that the skid plate is not twisted or bent.
Make sure that the Lexan
Do not twist or move the product to the sides while you cut. Gradually change
the pressure on the handlebar to control the blade in the cut.
Do a check that the motor operates correctly and at the specified rpm.
Do check that the tension of the belt and the belt idler are correct.
Make sure that the blade is correctly assembled and attached with clean flanges.
Make sure that the blade has the correct specification for your area or type of
concrete.
Make sure that the concrete surface is clean and that the skid plate can move
smoothly along on the concrete surface.
Use Husqvarna joint guards at all cut intersections.
Clean the blade block assembly.
Do a check that the scrapers in the blade block can move freely and that they
are not bent.
Make sure that the blade block shafts are not bent or damaged.
risk areas of the product. Be careful, prepare
the work and use common sense.
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
™
cover can move freely up and down.
1038 - 002 - 17.10.2019