Troubleshooting; Transportation, Storage And Disposal - Husqvarna FS 4600 G II Assembly & Operators Manual

Troubleshooting

WARNING:
blade stops, lift the cutting blade fully from
Problem Cause
The engine The fuel tank is empty.
stops during
The machine stop button is pushed down.
operation.
Too high load on the cutting blade.
A fuse is broken.
The cutting The tension of the drive belts are not sufficient.
blade stops
during opera-
tion.
The cutting The cutting blade is blunt or the feeding pres-
blade cuts too sure is too high.
slowly.
Incorrect gear is selected.
The battery is The ignition key is not in "0" position when the
drained. product is not in operation.
The machine stop button is pushed down to stop
the product.
The light kit or the water pump is on when the
product is not in operation.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product manually for
shorter distances. For longer distances, lift the product
to move it or put the product on a vehicle.
1657 - 001 - 08.09.2021
Troubleshooting
If the engine or cutting

Transportation, storage and disposal

Be careful during
the cut. Set the ignition key to the "0"
position and push the machine stop button.
Examine the product fully before you start
the product again.
Solution
Fill the fuel tank with correct fuel type.
Pull up the machine stop button to reset the ma-
chine stop.
Listen to the sound of the engine. If the engine
speed decreases, pull the lever for speed control
rearward.
Replace broken fuses.
Examine the tension of the drive belts.
Decrease the cutting depth and engine speed
for a short time.
Make sure that the correct gear is selected.
Move the gearshift lever to the applicable gear.
Turn the ignition key to the "0" position.
Always use the ignition key to stop the product.
Push down the switch for the light kit to make
the light kit go off. Push down the water pump
switch to disengage the water pump.
CAUTION:
behind a vehicle.
• Safety the product during transportation. Make sure
that it cannot move.
• Remove the cutting blade before transportation of
the product.
• Remove all tools and wrenches.
• For transportation of the product and fuel, make sure
that there are no leaks or fumes. Sparks or open
flames, for example from electrical devices or
boilers, can start a fire.
Do not tow the product
43