Selecting Video Cables - Toshiba S1 User Manual

video cables" below for guidelines on choosing a video cable,
then refer to
on page 65.
If you're connecting an SVGA monitor, skip to
an external monitor or projector" on page

Selecting video cables

To connect a device to the video-out port, you'll need to
purchase a composite video cable. For the best video quality,
always use a properly shielded cable.
HINT: Toshiba recommends using a cable no longer than
20 feet (approximately 6 meters).
Using a poor quality cable may result in a dull or fuzzy
picture, poor color, ghosting, video noise, or loss of video.
Connecting to the video-out (composite) port
Video cables are not included with your computer. To connect
NOTE
a device to the video-out port, you'll need to purchase a
composite video cable.
1 Connect one end of the video cable to the external video
device.
Refer to the documentation provided with the device for the
location of its video-in port.
2 Connect the other end of the video cable to the video-out
port on the left side of the computer.
3 Turn on the external video device.
4 Set the display mode by pressing
Display Properties settings. For more information, see
Connecting Other External Devices
Using external display devices
"Connecting to the video-out (composite) port"
"Connecting
66.
, or by setting the
Fn + F5
65