Advertisement
37
en | Installing
4
WARNING!
Risk of Damage!
!
Do not connect externally powered devices in wet mode. This
can damage the AMC2 4W-EXT.
Each relay output has a separate jumper setting on the
underside of the circuit board to select wet (D 2) or dry (D 1)
mode.
Figure 5.15 Location of relay output jumpers (bottom side)
NOTICE!
i
The positions of the jumpers 1 and 2 are interchanged related
to the corresponded interfaces.
| V 2.6 | 2008.12
diode
Installation manual
4
diode
5
voltage source
Bosch Sicherheitssysteme GmbH
AMC2 4W-EXT
Advertisement
