Table of Contents
Advertisement
Before installing the winch kit add or replace the
proper fluid to your front gearcase as required per
your vehicles service manual as this process will be
difficult to do after the winch is installed.
WINCH INSTALLATION
See the Electrical Connections Reference Guide
section of the instruction manual for detailed photos
of each part and their respective connections.
1. Check and confirm wire routing and connections
are as shown below and make necessary
adjustment before moving to next installation
steps.
If you have a Utility model, the brackets supporting
the front steel bumper will interfere with the blue and
yellow wires in the stock configuration as seen
above. You will need to loosen the nuts holding the
blue and yellow wires to the contactor, rotate them
as shown below, and then re-tighten the nuts. Refer
to image below for proper routing.
NOTE
NOTE
NOTE
Instr 9927475
2. Locate white contactor connection
assembly. If it is secured to the winch assembly
with a plastic tie, cut the tie to allow the wires to be
routed properly.
3. Install winch assembly
N
with the supplied four screws
wires are free to move and not pinched between
the vehicle chassis and the winch assembly.
Torque screws to below specification.
Rev 01 2017-02
Page 5 of 14
M
u
onto the radiator mount
t
. Check that all
TORQUE
20 ft. lbs. (27.1 Nm)
on winch
Advertisement
Table of Contents
