Table of Contents
Advertisement
WINCH INSTALLATION
See the Electric Connections Reference Guide on
the last page of the instruction manual for detailed
photos of each part and their respective connections.
1. Install winch mounting bracket with pre-assembled
w
winch
and Autostop Fairlead to the chassis
frame using four screws
screws to specification.
TORQUE
20 ft. lbs (27.1 Nm)
CONTACTOR INSTALLATION
a
1. Connect red cable
corresponding colored posts on contactor.
Similarly, connect yellow cable
i
cable
to the colored posts on contactor as
shown.
NOTE
1(
as shown. Torque
o
and black cable
to the
u
and blue
Instr 9927476
2. Place the contactor
on the bracket as shown. Contactor mounting
bracket holes are not threaded. You will need to
thread the holes by running the self-tapping
j
screws
3. Connect short red
vehicle bus bar on same posts as the battery red
and black cables are connected.
4. Feed the yellow
right side of the vehicle near the frame tube to the
winch as shown. Hook the cables to the
corresponding colored posts on winch. Slide the
black rubber boots on yellow and blue cables.
Rev 01 2016-11
Page 5 of 12
s
along with cables installed
in from the top as shown.
a
o
and black
u
i
and blue
cables down the
cables to the
Advertisement
Table of Contents
