Table of Contents
Advertisement
v You must remove the fiber-optic cable from the SFP module before you remove
v Four indicator lights on a mini hub provide status information. If an SFP module
v If you replace the SFP module and still experience problems, the FAStT700
Replacing a failed SFP module
When instructed by the storage-management software, complete the following steps
to replace an SFP module from the mini hub.
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
v Use of controls or adjustments or performance of procedures other than
DANGER
Attention:
the LC-LC Fibre Channel cable before you remove the SFP module.
1. Remove the LC-LC Fibre Channel cable from the SFP module that has failed.
the SFP module from the mini hub.
fails, the corresponding SFP port bypass indicator will be lit on the mini-hub. For
more information about indicator lights, see "Mini-hub indicator lights" on page 27.
Storage Server might have defective components or connections. Check the
storage-management software for indications of other component failures.
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
those specified herein might result in hazardous radiation exposure.
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following. Laser radiation when open. Do not stare into the
beam, do not view directly with optical instruments, and avoid direct
exposure to the beam.
To avoid damage to the cable or SFP module, make sure you remove
For more information, see "Handling fiber-optic cables" on page 3 and
"Removing an LC-LC Fibre Channel cable" on page 8.
Chapter 3. Replacing FAStT700 Storage Server components
53
Advertisement
Table of Contents
