3.7 SP505A, SP506A
These models protect equipment attached to Thick
Ethernet. (See Fig. 3-3.)
Intrusive taps
1. Remove the terminator.
2. Connect the protector to the end of the
segment.
3. Reconnect the terminator and ground the
protector to the terminator ground.
Nonintrusive taps
1. Disconnect the trunk cable from the
transceiver.
2. Connect the cable to the protector and
connect the protector to the transceiver.
3. Attach the ground wire to the transceiver.
CHAPTER 3: Installation
:
:
CHAPTER 3: Installation
1 9