Before Operation - Sharp R-21ATP Operation Manual

R-21at operation-manual gb
Hide thumbs Also See for R-21ATP:
Table of Contents

Advertisement

A30317, SUK R-21AT O/M
B
EFORE OPERATION
The operation of the oven is controlled by pressing the appropriate pads on the control panel.
A signal should be heard each time you press the control panel.
When you first connect the microwave oven to an
electrical socket, the digital display will show
.
Key pad entries can only be made when the door
is closed.
SOUND SETTING
There is a choice of 2 different sounds or no
sound on your oven.
STOPPING THE OVEN
If you want to stop the oven during cooking, press
the STOP/CLEAR pad once or open the door (ex-
cept memory cooking).
To start the oven again, close the door and press
the START pad within 1 minute.
The programme or check mode is cancelled when
any pads are not pressed for more than 3 min-
utes.
will appear on the display after the time
reaches zero. It will disappear when the oven door
is opened or the STOP/CLEAR pad is pressed.
To set a signal, touch the SET pad twice within 2
seconds and then touch the SIGNAL pad continu-
ously until you hear the tone required.
If you open the door during memory cooking, the
programme is cancelled.
If you want to cancel a programme during cook-
ing, press the STOP/CLEAR pad twice.
If you want to clear a mistake during program-
ming, press the STOP/CLEAR pad once.
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

R-21at

Table of Contents