Senco F-35XP Operating Instructions Manual page 11

LOADING THE TOOL:
Insert strip of nails into rear of magazine.
• Use only genuine SENCO fasteners (see Fastener Specifications).
• Do not load with workpiece contact (safety element) or trigger depressed.
Pull feeder shoe back.
UNLOADING THE TOOL:
Push Button on feeder shoe to release feeder from strip. Pull fastener strip out past sheet metal nail detainer.
Tool Operation
Read section titled "Safety Warnings," before using tool.
For best results, charge new battery before using. (see "To
Charge Battery" on page 14).
Indicator LED Indicator LED
ON-Flashing ON-Flashing
All Fusion tools are equipped with selective-actuation triggering.
This allows the user to choose between the following modes of
operation:
Indicator LED
Indicator LED
ON-Flashing ON-Flashing
Indicator LED
Indicator LED
ON-Solid ON-Solid
In the "contact-actuation" mode, nails can be driven in two ways:
TOOL OPERATION
The tool should be switched off
when not in use. Hold down either
side of the selector switch for 1
second to turn the tool off. If left
on, the tool will automatically turn
off after 60 minutes.
Contact Actuation
Pressing the side of the selector
switch toward the T T T symbol (as
shown) for 0.5 sec. will turn the
tool on in contact-actuation mode.
This is indicated by the flashing
green LED of the selector switch.
Sequential
Pressing the side of the selector
switch toward the T symbol (as
shown) for 0.5 sec. will turn the
tool on in sequential mode. This is
indicated by the solid green LED
of the selector switch.
A
3
1
2
B
2
1
3
In the "sequential-actuation" mode, nails can only be driven
one way:
3
1
2
11
The first way:
Press the T T T side of the
1.
selector switch for 0.5
seconds. This will be
indicated by the flashing
green LED on the selector
switch.
2. Press the workpiece
contact (safety) element
against the work surface.
3. Pull the trigger and the
fastener is driven.
The Second way:
Press the T T T side of the
1.
selector switch for 0.5
seconds. This will be
indicated by the flashing
green LED on the selector
switch.
2. Pull trigger.
3. Depress workpiece
contact element against
work surface and drive a
fastener.
This mode of operation is
preferred when you desire
high production, rapid fastener
placement.
1. Press the T side of the
selector switch for 0.5
seconds. This will be
indicated by the solid
green LED on the selector
switch.
2. Position workpiece
contact (safety) element
against work surface and
depress the safety.
3. Pull trigger to turn on the
motor and drive a single
fastener.
This mode of operation is helpful
when you require precise fastener
placement.
EN