Table of Contents
Advertisement
5-10.
Carry Loader Assembly
Preparation
1.
Remove the upper plate assembly. (Refer to
2.
Remove the bottom plate. (Refer to
3.
Remove the rear plate assembly. (Refer to
Procedure
1.
Disconnect the flexible flat cable from the connector (CN43) on the SM-44 board.
2.
Remove the two screws (M2 x 2.7) and the two screws (PSW2 x 5) to detach the carry loader assembly in the
direction of the arrow.
Note
Place the removed carry loader assembly with its bottom facing upward.
Carry loader assembly
CN43
SM-44 board
Flexible flat cable
M2 x 2.7
Note
When installing the carry loader assembly, note the following.
• Match the grooves with the plate.
• Match the two bosses with the two holes.
3.
Install the removed parts by reversing the steps of removal.
ODS-D77U/ODS-D77F
"5-1. Upper Plate
Assembly")
"5-4. Bottom
Plate")
"5-5. Rear Plate
Assembly")
Holes
Bosses
PSW2 x 5
Groove
Plate
The same applies to the other side.
M2 x 2.7
Groove
5-17
Advertisement
Table of Contents
