Table of Contents
Advertisement
5-7.
Front Plate Assembly
Preparation
1.
Remove the upper plate assembly. (Refer to
2.
Remove the bottom plate. (Refer to
3.
Remove the rear plate assembly. (Refer to
4.
Check that the select loader is at the cartridge eject position.
Procedure
1.
Remove the screw (2 x 2.7) and release the four claws to detach the front panel assembly.
2.
Disconnect the harness and flexible flat cable from the two connectors (CN1234, CN44) on the KY-717 board.
3.
Remove the power knob.
4.
Remove the two screws (B2.6 x 4) to detach the front plate assembly.
Note
Carefully remove and install the front plate assembly so as not to deform or damage portion A.
Power knob
Claw
2ｘ2.7
Claw
Front panel assembly
ODS-D77U/ODS-D77F
"5-1. Upper Plate
"5-4. Bottom
Plate")
"5-5. Rear Plate
Front plate assembly
CN1234
Claw
Claw
Assembly")
Assembly")
Harness
B2.6 x 4
Flexible flat cable
Flexible flat cable
Portion A
KY-717 board
CN44
(Type A)
5-12
Advertisement
Table of Contents
