Table of Contents
Advertisement
5-2.
IF-1234 Board (ODS-D77U Only)
Preparation
1.
Remove the upper plate assembly. (Refer to
Procedure
1.
Remove the screw to detach the t-clamp bracket.
2.
Disconnect the fine-wire coaxial cable and the four harnesses from the five connectors (CN2, CN4, CN5, CN512,
and CN717) on the IF-1234 board.
Fine-wire coaxial cable
IF-1234 board
CN2
CN4
Harness
3.
Remove the two screws (B2 x 3) to detach the t-leaf spring.
4.
Remove the screw (PSW2 x 5) to detach the washer, t-light guide shield (rear), and t-light guide (rear).
5.
Remove the screw (PSW2 x 5) to detach the clamp.
ODS-D77U/ODS-D77F
"5-1. Upper Plate
Assembly")
Harness
CN717
CN512
CN5
T-clamp bracket
PSW2.6 x 5.8
Harnesses
5-2
Advertisement
Table of Contents
