5-11.
Carry Motor
Preparation
1.
Remove the upper plate assembly (Refer to
2.
Remove the bottom plate. (Refer to
3.
Remove the rear plate assembly. (Refer to
4.
Remove the carry loader assembly. (Refer to
Procedure
1.
Remove the tension coil spring.
2.
Remove the two screws to detach the motor holder assembly.
3.
Disconnect the harness from the connector on the SM-44 board.
4.
Release the harness from the two clamps.
ODS-D77U/ODS-D77F
"5-1. Upper Plate
"5-4. Bottom
Plate")
"5-5. Rear Plate
"5-10. Carry Loader
Motor holder assembly
Tension coil spring
Assembly")
Assembly")
Assembly")
PSW2 x 5
5-18