Table of Contents
Advertisement
2-4-3. Preparation
1. Place this unit with the bottom side facing upward.
2. Open the terminal cover.
3. Remove the USB sheet, then set the switch (S1200) on the Q board to the lower side.
Keep the removed USB sheet.
Bottom side
4. Place this unit with the top side facing upward.
5. Connect the power cord to this unit.
6. Connect this unit and PC using the RS-232C cross cable.
7. Install the Laser Projector Service Tool software on PC.
8. Start the Laser Projector Service Tool software.
t
The read value of register is not updated automatically.
Click the [Read] button as required for updating to the latest information, and then use it.
VPL-FHZ65
Terminal cover
USB sheet
Q board
Set the switch (S1200) to lower side.
2-9 (E)
Advertisement
Table of Contents
