Connections On The Drive Module - ABB MultiMove Applications Manual

2.1.3. Connections on the drive module

Already connected at delivery
When a MultiMove system is delivered from ABB, the Ethernet cable and the safety signal
cable are already connected to the drive module. You only need to know how these cables are
connected if you ar going to change the hardware configuration or replace parts.
Connect the cables from the control module
xx0400001000
A
B
Connect the Ethernet cable to the Ethernet connection marked Computer module link.
Connect the safety signal cable according to
3HAC021272-001 Revision: H
B
Ethernet connection
Contactor interface board
2.1.3. Connections on the drive module
A
Safety signal connection on page
Continues on next page
2 Installation
22.
21