HYDRO-RAIN ORBIT SPRINKLER SYSTEM DESIGNER Installation Manual page 15

10. Install PIPe and fIttInGs foR sPRInKleR zones
We will now step you through the process of installing the Blu-Lock pipe from the heads to the valve
for each sprinkler zone (see "Working with Blu-Lock" in the appendix of this guide for additional helpful
information).
Start with one sprinkler zone and install the Blu-Lock pipe and fittings for that zone using the map as a
guide. It is important that you finish one zone before you start another to avoid confusion. Adjust the
sprinkler zone pipe head placement to actual conditions (i.e. utilities, window wells, trees, etc.).
As we walk you through this section we will use
the zone layout shown here to help you better
understand each step. Install all zones following
these steps, then go on to the next section.
1 Dig trenches for heads as needed
to place the head as close as
possible to the outside edges of
the sprinkler zone.
ORBIT SPRINKLER SySTEm DESIGNER™ InstallatIon GuIde
®
For heads located along sidewalks,
driveways, or curbs plan on spacing
heads 1" to 2" from the edge or
according to local code.