HYDRO-RAIN HRX-075 Quick Start Manual

Sprinkler rotor

Advertisement

Sprinkler Installation

Please Note: Do Not use pipe dope on threads! Use thread seal tape if necessary.
1. Flush sprinkler lines.
2. Thread the sprinkler rotor onto a swing joint assembly and set the head flush with the
finished turf height.

Set the Spray Distance after installation

Please Note: Set with water on at normal system operating pressure. Nozzle #2 is preinstalled
and adjusts from 25 - 45 feet depending on your water pressure.
1. Insert the metal hex end of the adjusting key into thew distance adjustment slot.
2. Turn clockwise to decrease distance or counter-clockwise to increase distance.
*Caution: Do Not turn the adjustment screw too far in either direction as the screw may come
loose from threads.
Hydro-Rain HRX-075 Sprinkler Rotor

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HRX-075 and is the answer not in the manual?

Questions and answers

Summary of Contents for HYDRO-RAIN HRX-075

  • Page 1 Hydro-Rain HRX-075 Sprinkler Rotor Sprinkler Installation Please Note: Do Not use pipe dope on threads! Use thread seal tape if necessary. 1. Flush sprinkler lines. 2. Thread the sprinkler rotor onto a swing joint assembly and set the head flush with the finished turf height.
  • Page 2 Pattern Adjustment The HRX 075 is preset for 180-degree operation. The pattern can be adjusted for operation between 40 and 360 degrees. 1. Turn the top of the head all the way to the left until it stops and then all the way to the right.
  • Page 3 Nozzle Specifications Standard Nozzles...
  • Page 4 Low Angle Nozzles...

Table of Contents