Language Selection; Application Selection - Honeywell NX series User Manual

7.3.6.1

Language selection

The HMI control keypad offers the user the possibility to control the frequency converter through the
keypad in the language of your choice.
Locate the language selection page under the System menu. Its location indication is S6.1. Press the
button right once to enter the edit mode. As the name of the language starts to blink you are able to choose
another language for the keypad texts. Confirm the selection by pushing the
stops and all textual information on the keypad is presented in the language you chose.
You can return to the previous menu anytime by pushing the
I/Oterm
System Menu
I/Ot erm
Language
English
Figure 7-9. Selection of language
7.3.6.2

Application selection

The user can select the application desired by entering the Application selection page (S6.2). This is done
by pushing the Menu button right
by pushing the Menu button right once again. The name of the application starts to blink. Now you can
browse through the applications with the
button.
Changing application will reset all parameters. After application change, you will be asked if you want the
parameters of the new application to be uploaded to the keypad. If you wish this to happen push the
button Pushing any other button leaves the parameters of the previously used application saved in the
keypad. For more information, see Chapter 7.3.6.3.
For more information about the Application Package, see NX Application Manual.
CONTROL KEYPAD
READY
S1 S11
READY
when on the first page of the System menu. Change then the application
Browser buttons
Menu button
READY
I/Ot erm
Language
English
READY
I/Oterm
Langue
enter
Francais
and select another application with the
91(110)
Enter button The blinking
left.
Enter
7
Menu
Enter