Fault History Menu (M5) - Honeywell NX series User Manual

7
88(110)
7.3.5

Fault history menu (M5)

The Fault history menu can be entered from the Main menu by pushing the
location indication M5 is visible on the first line of the keypad display. Find the fault codes in Table 7-4.
All faults are stored in the Fault history menu in which you can browse through them using the
buttons. Additionally, the Fault time data record pages (see Chapter 7.3.4.3) are accessible at each fault.
You can return to the previous menu anytime by pushing the
The memory of the frequency converter can store a maximum of 30 faults in the order of appearance. The
number of faults currently in the fault history is shown on the
order of the faults is indicated by the
fault carries the indication F5.1, the second latest F5.2 etc. If there are 30 uncleared faults in the memory
the next occurring fault will erase the oldest from the memory.
Pressing the Enter button
change to 0.
READY
I/Oterm
Fault history
H1 H3
Figure 7-8. Fault history menu
CONTROL KEYPAD
location indication
for about 2 to 3 seconds resets the whole fault history. Then, the symbol H# will
I/Oterm
5 ChargeSwitch
I/Oterm
11 Output phase
PUSH
Menu button left.
value line of the main page (H1 H#). The
in the upper left corner of the display. The latest
READY
T1 T7
to reset
enter
Menu button right when the
Browser
I/Oter m
Operation hours
13:25:43
READY
I/Oterm
Operation days
17