Honeywell NX series User Manual page 72

CABLING AND CONNECTIONS
Jum per block X 1 :
AI1 m ode
A B C D
AI1 mode: 0...20mA; Current input
A B C D
AI1 mode: Voltage input; 0...10V
A B C D
AI1 mode: Voltage input; 0...10V (differential)
A B C D
AI1 mode: Voltage input; -10...10V
Jum per block X 6 :
AO 1 m ode
A B C
AO1 mode: 0...20mA; Current output
A B C
AO1 mode: Voltage output; 0...10V
= Factory default
Figure 6-31. Jumper selection for OPT-A1
!
If you change the AI/AO signal content also remember to
change the corresponding board parameter in
NOTE
AI2 mode: 0...20mA; Current input
AI2 mode: Voltage input; 0...10V
AI2 mode: Voltage input; 0...10V (differential)
AI2 mode: Voltage input; -10...10V
CM A a nd CM B grounding
D
D
Jum per block X 2 :
AI2 m ode
A B C D
A B C D
A B C D
A B C D
Jum per block X 3 :
CMB connected to GN D
CMA connected to GN D
CMB isolated from GN D
CMA isolated from GN D
CMB and CMA
internally connected together,
isolated from GN D
menu M7.
6
71(110)