Parameter Comparison - Honeywell NX series User Manual

7
94(110)
7.3.6.4

Parameter comparison

In the Parameter comparison submenu (S6.4), you can compare the actual parameter values to the
values of your customised parameter sets and those loaded to the control keypad.
The comparison is performed by pushing the
submenu. The actual parameter values are first compared to those of the customised parameter Set1. If no
differences are detected a '0' is displayed on the lowermost line. But if any of the parameter values differ
from those of the Set1 the number of the deviations is displayed together with symbol P (e.g. P1 P5 = five
deviating values). By pressing the Menu button right once again you can still enter the pages where you
can see both the actual value and the value it was compared to. In this display, the value on the
Description line (in the middle) is the default value and the one on the
value. Furthermore, you can also edit the actual value with the
can reach by pushing the Menu button right once again.
In the same way, you can perform the comparison of the actual values to Set2, Factory Settings and
Keypad Set.
ParamComparison
C1 C3
Figure 7-13. Parameter comparison
CONTROL KEYPAD
READY
Set1
OR
Set1
P2.1.2= 50.0
Menu button right when in the Compare parameters
Browser buttons
READY
0
READY
P2.1.2= 50.0
P1 P6
READY
20.0 Hz
enter
value line (lowermost) is the edited
in the edit mode that you
READY
20.0 Hz
EDIT VALUE
CONFIRM CHANGE