2.3.10. MINI-USB connector
The mini-USB connector has 2 functions
1. Power supply through a wall mounted transformer. This transformer supplies a
regulated 5V/1A DC voltage.
2. Measurement transmission. If you connect your M3 to a PC, the PC will detect
and install automatically the M3 as a standard USB keyboard with the standard
drivers of your operating system (Windows, Mac OS etc..). When you send the
measurement, the value will be written on your PC screen where your cursor
is, in the same way as it would have been typed with a keyboard.
Message that appears when the M1/M3 has been correctly installed:
2.3.11. The 24VDC connector
It is advised to use this power supply when the M3 is panel mounted.
Using this power supply instead of the mini-USB will deactivate the ON-OFF switch.
Therefore, when the M3 is powered, it will start automatically.
2.3.12. The USB stick connector
It is possible to save measurements on a CSV file.
In this case the display must be set the following way:
Configuration Transfer USB key
Then once the user either press on the « PRINT » button of the measuring screen or
on the footswitch, one line will be added on the CSV file. (a « output.csv » file is
created when the operator transfers the data for the first time). When the USB stick
has been correctly detected, a USB logo will appear on top bar. If the USB stick is not
connected when the operator transfers the measurement, an error message will pop
up. USB sticks with partitions are not supported.
2.3.12. The footswitch connector
Page 20
M1 – M3 Display Units