Command Sequence and Advanced Comms
Write Command
Writes can be up to 128 bytes, and called as a single device write, broadcast write, stack write, or
reverse direction broadcast write.
A range of registers can be written to by simply choosing the starting register address, then writing enough
bytes in the "Bytes to Write" section to fill the desired range, as seen in
instance, if you choose "Register Address" 10E, then provide "82828282" in the "Bytes to Write" section,
registers 10E to 111 (4 registers total) will be overwritten with "82".
24
Getting Started with the BQ79606A-Q1 GUI
Figure 31. Read Command
Figure 32. Write Command
Copyright © 2017–2019, Texas Instruments Incorporated
Figure 32
or
Figure
33. For
SLUUBQ2C – July 2017 – Revised April 2019
Submit Documentation Feedback
www.ti.com