Registers; Bit Level Register Map; Spi Master Configuration - Texas Instruments BQ79606A-Q1 User Manual

www.ti.com
To enable SPI across GPIO3-GPIO6, check the "Enable SPI" checkbox provided (#1 in
the desired settings for CPOL, CPHA, SS, and SPI Transaction length (1 to 8 bits long) are correct. There
is loopback functionality provided by the "Enable Loopback" checkbox, as well as boxes for
transmitting/receiving the SPI data (#2 in
desired byte in the "SPI Transmit" box, in hex (#3 in
Only)" button to send/receive the data (#4 in
7

Registers

7.1

Bit Level Register Map

Displays a register map of all user addressable registers in the BQ79606A, as well as allowing for bit level
read and writes.
SLUUBQ2C – July 2017 – Revised April 2019
Submit Documentation Feedback
Figure 22). You may send 1 byte of data over SPI by writing the
Figure
Figure 22).
Figure 22. SPI Master Configuration
Copyright © 2017–2019, Texas Instruments Incorporated
22). Then use the "Execute SPI (Single Device
Getting Started with the BQ79606A-Q1 GUI
Registers
Figure 22). Ensure
17