Function Settings; Operation Modes - Duplo DF-850 Instruction Manual

2
Rotate the slant correction knob in the
direction of the arrow shown in the
figure, to adjust the misalignment.
3
After the operation is ended, return
the slant correction knob to its original
position.
The guide is a position where pin align with
round hole in the paper feed tray.
7.

Function Settings

Function settings can adjust in support of operating procedures or various paper types, according to use.
7-1.

Operation modes

Operation mode refers to setting operations for the stoppers for the folding plate 1 and folding plate 2 when
the power is first turned on.
[STD] (Standard)
[LF] (Last fold mode)
[SF](Stopper fixed mode)
Function for starting up in the normal setting condition when the power is turned on.
Function for starting up using the setting last used on the machine the previous time.
If the power is turned off during paper folding operation, the setting information is not
stored.
Function for omitting the operations panel setting when always processing using the
same conditions.
The machine is constantly set automatically using the same conditions.
When the power is turned on, the initial operation is no longer performed.
Because automatic setting is performed under the same conditions, the paper size and
folding mode cannot be changed.
Folding misalignment in the up or down direction will occur if the power is turned
on after turned off during operation of the folding stopper or during temporary stop
caused by opening the cover. In this case, be sure to press the C key while pressing the
key to forcibly eject paper when you turn on the power.
Copyright © 2018 Duplo Corporation All Rights Reserved
Chapter 3 Advanced Operation
[b]
[a]
Circular hole
Pin
49