Lutron Electronics Maestro MS-OPS2 1 Series Manual page 17

Maestro
Wiring Diagrams
Wiring Diagram 8 - with Neutral
3-way Installation with Standard Mechanical Switch (120 V~)
-OPS6M2U-DV, -VPS6M2U-DV
Hot / Live
Jumper wire
120 V~
50 / 60 Hz
Neutral
OR
Hot / Live
120 V~
50 / 60 Hz
Neutral
Note: When a neutral connection is available, connect the white-sleeved wire to neutral.
1
When using controls in single location installations, tighten the blue terminal or cap blue wire. Do NOT connect the blue terminal / wire to any other
wire or to ground.
2
Fan load applies to 120 V~ only (not for 277 V~).
3 Only one occupancy sensor switch can be used per multi-location circuit.
4
A single standard mechanical 3-way switch or up to 9 companion switches may be connected to most occupancy sensor switches.
Standard mechanical 3-way switch cannot be combined with companion switch. Total blue terminal wire length may be up to 150 ft (46 m).
S P E C I F I C AT I O N S U B M I T TA L
®
Job Name:
Job Number:
Switch with Occupancy / Vacancy Sensor
(continued)
Standard
mechanical switch
Different color
screw (Common)
Green
screw
Ground
Occupancy
sensor switch
Black
Black
Blue
Bare
White-sleeved
Ground
wire
Model Numbers:
3, 4
Occupancy
sensor switch
Black
Black
Blue
Bare
White-sleeved wire
Ground
Standard
mechanical switch
Different color
screw (Common)
Jumper wire
Green
screw
Ground
Sensor
369666f 17 09.05.19
Load
Load
Continued on next page...
Page
17