Subscribe to Our Youtube Channel
Related Manuals for zortrax Endstop Sleeve
Summary of Contents for zortrax Endstop Sleeve
- Page 1 Endstop Sleeve Installation SOURCE: https://support.zortrax.com/endstop-sleeve-installation/ page 1 / 12...
-
Page 2: Table Of Contents
Unplugging the Power Cable Unplugging the Extruder Cable Loosening the Screws on the Axis Block Unscrewing the Axis Block Cover Endstop Sleeve Installation Securing the Axis Block Cover Tightening the Screws on the Axis Block Plugging the Extruder Cable Plugging the Power Cable... - Page 3 The endstop sleeve is responsible for pressing the lever of the endstop once the extruder reaches the end of the axis. This action immediately informs the printer that the extruder should stop moving and not crash into the housing. Therefore, if...
-
Page 4: Unplugging The Power Cable
Unplugging the Power Cable Turn off the printer and unplug the power cable. page 4 / 12... -
Page 5: Unplugging The Extruder Cable
Unplugging the Extruder Cable Unplug the extruder cable. page 5 / 12... -
Page 6: Loosening The Screws On The Axis Block
Loosening the Screws on the Axis Block Move the extruder toward the axis block on which you will install the endstop sleeve. Loosen the two screws placed at the bottom of the opposite axis block using a 1.5mm Allen key. -
Page 7: Unscrewing The Axis Block Cover
Move the extruder toward the opposite axis block. Unscrew the two front screws on the axis block on which you will install the endstop sleeve. Use a 2mm Allen key. Slightly move the axis block cover away from the block to gain easier access to the place where the endstop sleeve should be screwed in. -
Page 8: Endstop Sleeve Installation
Endstop Sleeve Installation Turn the axis block and screw in the endstop sleeve using a 2mm Allen key. Turn the axis block to its previous position. page 8 / 12... -
Page 9: Securing The Axis Block Cover
Securing the Axis Block Cover Push the axis block cover closer to the block and secure it with the two screws. page 9 / 12... -
Page 10: Tightening The Screws On The Axis Block
Tightening the Screws on the Axis Block Move the extruder toward the opposite axis block. Tighten the two screws placed at the bottom of the axis block using a 1.5mm Allen key. page 10 / 12... -
Page 11: Plugging The Extruder Cable
Plugging the Extruder Cable Plug the extruder cable in. page 11 / 12... -
Page 12: Plugging The Power Cable
Plugging the Power Cable Plug the power cable in. page 12 / 12...
Need help?
Do you have a question about the Endstop Sleeve and is the answer not in the manual?
Questions and answers