Before leaving the fitting, the following points should be checked:
O
P
D)
N THE
ANEL
-
Display shows the welcome message
-
Check that the keypad keys (0, 1, 2
Procedure:
o Press #; the display shows "Call number"
o The numeric keys must be displayed correctly
o Finish using the * key; the display should return to the welcome message.
-
Check that the keypad keys are backlit.
D
E)
OOR CONNECTION
-
Check door opening with the push button
-
Check door opening using a badge
C
F)
ALLS
-
Check the quality of a call by a visitor to a resident:
o Audio Call
o Video Call
-
Check that, during the call, the resident can open the door by pressing the * key on
his/her telephone
I
G)
N THE CASE OF A FITTING WITH A
If you use a 3G unit with your call panel, you can see the signal reception level for the unit
by pressing the 2 scrolling arrow keys
Depending on the situation, you will see:
"3G NET Lev
17
3" or "GSM NET Lev
-
NET : shows that the network has been found by the unit (3G or GSM)
-
Lev
: shows the level out of 30
(here
3
/ 5)
Press one of the arrow keys to exit from this menu.
I
H)
N THE CASE OF A FITTING WITH A
Remember to make a note of the serial number (7XXXXXX3) of the central unit.
You will need this to go back into the installation and configure these settings on the
keypad outside.
EN-V233 – 5004 – AA Installation and use of call panel + key safe EEN-PVIBCV3
POST-FITTING CHECK
(See Test Procedure in the central unit guide)
(See Test Procedure in the central unit guide)
֠ ֠ ֠ ֠
17
(here,17
9, * and #) work.
3G
UNIT
on the display.
3
»
/ 30) and the connection on a scale of 5
EEN-CIC12
CENTRAL UNIT
Page 9 / 12
Need help?
Do you have a question about the Visio and is the answer not in the manual?