Notes On Safety; Notes On Safety Emergency Lock; Opening; Locking - Wittkopp Primor Level 25 Quick Start

Primor Level 25 - Quick start

1 Notes on safety

• Due to security reasons change the factory code of 1 2 3 4 5 6 7 immediately.
• For your new code, do not use any personal data like birthdays or any other data, which could be known by knowledge of
your person.
• Simple codes that can be guessed easily i.e. 1 2 3 4 5 6 7 must not be used.
• Your code has to be secret.
• Don't write down your code.
• Don't safe your code on your PC, a DVD, a USB-stick or your mobile.
• Change your code frequently for example every three months.
• After entering the new code, the electronic lock should be opened and locked several times with the safe door opened.
• After each locking doublecheck if the safe is closed.

1.1 Notes on safety emergency lock

• Due to security reasons it is recommended not to leave the key unattended in the lock.
• Don't store the key in the safe.
• The keys have to be stored at a safe place and may only be accessible by authorised persons.
• When losing the key exchange the lock immediately.
• Make sure after each locking if the safe is locked.
Detailed installation/operating instructions are available for download on our website carl-wittkopp.com.

2 Opening

Before a user is created the master can operate the lock on his own. Point 2 is not applicable.
As soon as 1 user is created the lock only works in dual verification process.
1. User 1: Enter your 7-digit code. (Factory master code 1 2 3 4 5 6 7).
2. User 2: Enter your 7-digit code within 3 seconds.
3. Turn the handle within 3 seconds into opening position.

3 Locking

1. Close the door at the safe and turn the handle into locking position.

4 Programming the user code

The master is able to program the user code, but not vice versa.
When adding a user for the first time point 1 is not applicable.
1. Enter your 7-digit user code.
2. Press and hold the key "1" until the red LEDs flash permanently.
3. Enter your 7-digit master code.
4. Enter the 1-digit user PIN which has to be programmed (between 1 and 9).
5. Enter the new 7-digit user code.
6. Re-enter the new 7-digit user code.

5 Changing the master or user code

1. Press and hold the key "0" until the red LEDs flash permanently.
2. Enter your old 7-digit code.
3. Enter your new 7-digit code.
4. Re-enter your new 7-digit code.
Rel. 1.1 12.01.2017
© Carl Wittkopp GmbH - Errors and omissions excepted
Quick start no. 600-0002-00-0