Agrison HP ULTRA Series Operation Manual page 41

choose the power output shaft speed. Pull up the PTO control handle, it reach
higher shift 1000r/min; press it, reach lower shift 720r/min or 540r/min.
○
when you don't need power output, PTO control handle should be in neutral
7
position, install and fasten traction bracket and PTO cover.
2.16.4.4 Synchronous power output shaft
Synchronous power output shaft main use matching driving trailer. The
model of wheel and reduce speed rate of driving trailer must according to the
speed of synchronous power output to choose.
Synchronous power output shaft driving by transmission device, not driving
by diesel engine directly. When tractor stopping, the PTO is also stopping
moving. When the forward shift change reverse shift, the synchronous power
output change moving the direction, too.
Synchronous power output of 540r / min, rear wheel moving each 1 circle,
power output shaft moving 17.28 circles ; Synchronous power output of 1000r /
min, rear wheel moving each 1 circle, power output shaft moving 28.22 circles.
Using synchronous power output shaft, it should pull up the PTO control
handle, other operate steps as independent power output shaft.
Warning:
1. Power output connection, it forbid everyone nearly agricultural implements,
as to prevent arising dangerous.
2. Mustn't connect with synchronous power output when tractors are driving.
2.16.5 Operation of towing device
2.16.5.1 Pendulum type draw bar
The pendulum type draw bar is only used for the trailed implements. The rear end of the
drawbar is connected to the farm tools through the towing pin and the drawbar can swing laterally
for the convenience of the connection with the farm tools. During operation, the drawbar can swing
left and right. However, when the tractor wants to draw the farm tools back, it is necessary to insert
two locating pins into the holes of draw plate to prevent the drawbar from swinging. To change the
height of towing point, it is allowed to turn the drawbar to create the towing height applicable to the
farm tools.
2.16.5.2 Hook bracket
The hook is applied to various trailers, not used with the pendulum type draw bar.
Warning:
1. The overload is not allowed at the towing operation and the operation with trailer.
2. When braking, the trailer shall be braked slightly prior to the tractor.
Operation Instruction
-29-