Agrison HP ULTRA Series Operation Manual page 38

hydraulic output.
Picture 2-4 Hydraulic output device
1.快换接头
2.操纵手柄
3.多路阀输油管
When using hydraulic quick-change coupler to implement connection, the following work need
to be finished at first, and then the female connector on the agricultural machinery can be inserted
into connector assembly:

Stop the engine;

Drop the suspension agricultural machinery;

Move the hydraulic output valve operation handle front and end, so as to eliminate
pressure in the hydraulic quick-change connector assembly;

Take down the seal cap of the quick-change connector, and clear the quick-change
connector.
Important matters:
1. When the quick-change connector is not used, the assembly hole must be covered
well by dust cover to prevent dust from entering;
2. The raiser and the hydraulic output valve can not be used simultaneously;
3. After the operation of the hydraulic output valve is finished, the operation handle
must go back to the neutral position; otherwise overheating of the hydraulic system will be
caused.
Important matters:
1. When tractor which is hanging suspension agricultural machinery is transferring a
long distance, adjust the upper pull rod to the shortest position, and adjust the limit rod to
prevent the agricultural machinery from swing left to right, simultaneously tighten the lock
nut on the upper pull rod and the limit rod;
2. When the tractor is turning a corner at the edge of the field, the agricultural
-26-
Operation Instruction
4.多路阀总成
5.多路阀支架
6.回油管总成
图 2-5 多路阀总成
1.单双作用转换螺钉"E"