Braking Of The Tractor; Stopping Of Tractor Stop And Flameout Of Engine - Agrison HP ULTRA Series Operation Manual

2.9 Braking of the Tractor

Generally, firstly decrease the throttle, step on the clutch pedal, and then gradually step on
the brake pedal according to the condition to steadily pause the tractor.
For emergency stop, you shall simultaneously step on the clutch and the brake pedal and
cannot solely step on the brake pedal, so as to prevent rapid abrasion of the brake friction plate or
causing engine stop.
When a trailer is added for braking, you shall adjust the length of the brake valve hang rod to
firstly brake the trailer and then brake the main engine.
When the tractor is running on road, you shall lock the left brake pedal and the right brake
pedal together by the chain board.
Warning
1. Before departure of each time, you shall uniformly check the oil level of the brake oil
tank as well as whether there is oil leakage generated at the brake piping or not; if the oil
level of the oil tank is too low or there is oil leakage generated at the brake piping, you shall
timely find out the reason, repair it, otherwise major incident like brake failure will be
raised.
2. When the tractor is running on road, you must interlock the left brake pedal and the
right brake pedal together, so as to prevent off tracking and even overturning of the tractor
when braking.

2.10 Stopping of Tractor Stop and Flameout of Engine

Flameout of the tractor and stopping of the tractor shall follow the following procedures:

Decrease the throttle, and reduce the running speed of the tractor.

Step on the clutch pedal, then step on the brake pedal and place the gear shift lever at
the position of neutral gear after the tractor stops

Loosen the clutch and brake pedal, and then decrease the throttle to lead the engine run
under idle speed.

Pull the flameout pull rod back, the oil pump stops supplying oil and the engine shuts
down immediately, and then push it to the position of oil supply

Turn the power switch to the off position, and shut down all the power sources.
Operation Instruction
:
-19-