Chapter 3
Configuration
General Port Settings
PCMCIA Serial for Windows NT
4.
Click on the Resources button in the General Port Settings dialog
box to view or configure the resources for the port. Refer to the
Resource Settings
5.
Click on Delete to remove hardware information about the port from
Windows NT. You should do this before you physically remove your
PCMCIA card.
6.
Click on Add to configure resources for a new PCMCIA card.
This section describes the options you can set in the General Port Settings
dialog box, shown in Figure 3-2.
Figure 3-2. General Port Settings Dialog Box
section, later in this chapter, for more information.
3-2
ni.com