National Instruments PCMCIA-232 Getting Started page 51

Index
four-wire mode, 4-1
full duplex, A-3
full-duplex system (figure), A-4
G
general port settings, 3-2
COM port number, 3-3
dialog box (figure), 3-2
FIFO enabled, 3-3
resources, 3-3
transceiver mode, 3-3
general programming requirements, 4-4
getting started, 1-2
glossary, G-1
H
half duplex, A-4
half-duplex system (figure), A-4
hardware installation, 2-3
getting started, 1-2
verification, 2-5
hardware specifications, D-1
I
installation
determining port associated with
COMx, 2-5
getting started, 1-2
PCMCIA serial card installation
(figure), 2-4
running the diagnostic test, 2-5
selecting resources for the PCMCIA
card, 2-4
serial hardware, 2-3
serial software, 2-1
verification, 2-1
verifying hardware installation, 2-5
introduction, 1-1
PCMCIA Serial for Windows NT
L
LabVIEW, 1-3
using with serial hardware, 1-4
LabWindows/CVI, 1-3
using with serial hardware, 1-4
M
missing serial port in the niports list, C-1
multidrop network using terminating resistors
(figure), A-5
N
naming National Instruments serial ports, C-3
National Instruments Web support, E-1
NI Developer Zone, E-1
NI serial setup screen (figure), 2-3
niports configuration utility (figure), 3-1
null-modem cabling in a DTE-to-DTE
interface (figure), A-6
O
optional equipment, 1-2
overview of serial hardware, 1-2
overview of serial software, 1-3
P
PCMCIA card installation (figure), 2-4
PCMCIA serial card physical characteristics
(table), D-1
PCMCIA-485, 2-7
advanced transceiver control for, 4-1
setting transceiver control mode, 4-2
transceiver mode control modes
(table), 4-1
two-wire mode: DTR controlled, 4-2
I-2 ni.com