This installation backs up the Microsoft Windows NT serial driver
Note
serial.bak
Windows NT
Install the PCMCIA Serial Hardware
© National Instruments Corporation
The setup wizard guides you through the necessary steps to install the
NI-Serial software. You can go back and change values where
appropriate by clicking on the Back button. You can exit the setup
where appropriate by clicking on the Cancel button.
and then overwrites
...\system32\drivers
The software installation is complete. Proceed to the next section, Install
the PCMCIA Serial Hardware.
Complete the following steps to install the PCMCIA-232 or PCMCIA-485
in your computer:
1.
Shut down the computer.
2.
Insert the card into a free PC Card (PCMCIA) socket the same way you
insert a disk into a floppy drive. The card has no jumpers or switches
to set.
3.
Power on the computer and start Windows NT.
Figure 2-2. NI-Serial Setup Screen
. You can find
serial.sys
directory.
2-3
Chapter 2
Installation and Verification
serial.sys
in the
serial.sys
PCMCIA Serial for Windows NT
to