National Instruments PCMCIA-232 Getting Started page 53

Index
T
technical support resources, E-1
termination, A-5
multidrop network using terminating
resistors (figure), A-5
time-saving development tools, 1-3
transceiver control modes (table), 4-1
transceiver mode, 3-3
setting with DeviceloControl, 4-3
troubleshooting, C-1
diagnostic messages, C-2
missing serial port in the niports list, C-1
resolving resource conflicts, C-1
two-wire devices, 2-7
connecting, 2-7
typical full-duplex system (figure), A-4
typical half-duplex system (figure), A-4
PCMCIA Serial for Windows NT
U
uninstalling serial hardware, B-1
uninstalling serial software, B-2
using serial hardware, 4-1
using this manual, 1-1
V
verifying hardware installation, 2-5
viewing or changing communication port
settings, 3-1
W
Web support from National Instruments, E-1
worldwide technical support, E-2
I-4 ni.com