Table of Contents
Advertisement
Chapter 2
Step 3. Install the AT-MXI Hardware
In the space provided here, record the settings of the base I/O address, the DMA channel(s), and
the interrupt level(s) for future reference. You will need this information when you install the
software.
Base I/O Address
Board Interrupt Level
MXIbus Interrupt Level
Master DMA Channel
Slave DMA Channel
Before attempting to install the AT-MXI, notice that some MXIbus cable connector hoods are
slightly wider than most standard connector hoods and might interfere with other cables installed
in adjacent PC AT slots. Normally, this will only be a problem if the cable connector hoods for
the adjacent slots are also oversized. When choosing a PC AT slot in which to install the
AT-MXI, verify that the MXIbus cable connector will not interfere with cables and connectors in
other PC AT slots. If necessary, reposition the boards in the system to prevent cabling conflicts.
It may also help to install the AT-MXI in one of the end slots so that you will only have to
contend with the cable connectors of one other board.
If you cannot configure the AT-MXI to co-exist in an existing PC AT system by repositioning
the boards, you can use one of the MXIbus cable options with a standard connector hood on the
cable end that attaches to the AT-MXI. The standard connector hood is narrower than the
MXIbus dual-connector arrangement and provides an easier fit for many system configurations.
However, this approach requires that the AT-MXI be the first device in the MXIbus daisy-chain
because a cable with a single connector end cannot accept another MXIbus cable to propagate
the bus. Remember that the first device in the MXIbus daisy-chain must also be configured as
the MXIbus System Controller.
The following instructions are general installation instructions. Consult the user or technical
reference manual of your computer for specific instructions and warnings.
1. Plug in your PC AT computer before installing the AT-MXI. The plug grounds the computer
and protects it from electrical damage while you are setting up.
Warning:
To protect both yourself and the computer from electrical hazards, the
computer should remain off until you are finished installing the board.
2. Remove the top cover or access port to the PC AT I/O bus.
© National Instruments Corporation
AT-MXI
2-11
Hardware Configuration and Installation
Setting
VXI-AT2022/NI-VXI SCO UNIX Getting Started
Advertisement
Table of Contents
