Advertisement
Figure 7 Installing the Mounting Bracket to a European Wall Box
2. Route the Ethernet cable through the back of the mount housing, as shown in
cable to the ENET port on the back of the access point.
3. Once the cable is connected to the access point, align the pins on the rear panel of the access point with
the slots on the mount housing. Press the button on the bottom of the mount housing and slide the
access pint into the slots. Release the button to secure the access point to the mounting bracket. See
Figure
4. To lock the access point to the mounting bracket, insert the T6 Torx security screw into the hole beside
the button, located at the bottom of the mount. then tighten until the screw is snug.
6
6.
Figure
7. Connect the
AP-310-MNT-W3
| Installation Guide
Advertisement
