Advertisement
3. Once the holes are drilled, remove the template and position the mounting bracket flat against the
surface. Align the holes of the mounting bracket with the pre-drilled holes, then screw the housing in
place.
Screws for
4. Press the RJ45 coupler into the housing located in the upper corner of the mounting bracket until locked
into place in the housing as shown in
Figure 1 Attaching the RJ45 Coupler to the Mount
5. Remove the RJ45 cable from the bag and insert the end into the inner-facing port of the coupler. See
Figure
2
step 3
are not provided in this kit. The screw used for this step will vary depending on the surface.
2.
Figure
1.
AP-310-MNT-W3
| Installation Guide
Advertisement
