Connecting The Headset (Optional); Connecting The Power (Optional) - Nortel 1230 User Manual

Installing your IP Phone 1230
1. Plug the end of the handset cord with the short straight section into
the handset.
2. Plug the other end of the handset cord with the long straight section
into the handset jack marked with the
Phone.
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.

Connecting the headset (optional)

If you have a headset, you can connect the headset to the IP Phone. For
information on how to use your headset with your IP Phone, see the IP
Phone 1200 Series User Guide (NN40010-302).
1. Plug the headset cord into the headset jack on the back of the IP
Phone marked with the
2. Thread the cord through the channel in the side of the foot stand.
3. Set up the headset according to the headset instructions.

Connecting the power (optional)

Your IP Phone supports AC power and Power over Ethernet (PoE). For
AC power, use only the Nortel-approved Global Power Supply
(N0146475) and the country-specific IEC cable that you can order
separately. To use PoE, your connected LAN must support PoE.
Note: Your IP Phone 1230 supports AC power and PoE options,
including IEEE 802.3 standard power. To use local AC power, you
can order separately the optional AC adapter. To use PoE, where
power is delivered over the CAT5 cable, the LAN must support PoE,
and you do not need an AC adapter.
36
)
symbol.
CAUTION
Use your IP Phone 1230 with the
approved Nortel AC Adapter (model
#N0089601).
+
symbol on the back of the IP