Ace Software Operation; Launching The Software; Description Of Chip View Window - Analog Devices EVAL-AD7383FMCZ User Manual

UG-1770
ACE SOFTWARE OPERATION

LAUNCHING THE SOFTWARE

After the EVAL-AD7383FMCZ and
connected to the PC, launch the ACE software by taking the
following steps:
1. From the Start menu of the PC, select All Programs >
Analog Devices > ACE> ACE.exe to open the ACE
software main window shown in Figure 12.
2. If the EVAL-AD7383FMCZ is not connected to the USB
port via the SDP-H1 when the software launches, the
AD7383 Eval Board icon does not appear in the Attached
Hardware section in ACE (see Figure 12).To make the
AD7383 Eval Board icon appear, connect the EVAL-
AD7383FMCZ and the SDP-H1 to the USB port of the PC,
wait a few seconds, and then follow the instructions in the
dialog box that opens.
3. Double click the AD7383 Eval Board icon to open the
AD7383 Eval Board view window shown in Figure 13.
EVAL-AD7383FMCZ
SDP-H1 are properly
Figure 12. ACE Software Main Window
Rev. A | Page 10 of 16
Evaluation Board User Guide
4. Double click the AD7383 chip icon in the AD7383 Eval
Board view window to open the AD7383 chip view
window shown in Figure 14.
5. Click Software Defaults and then click Apply Changes to
apply the default settings to the

DESCRIPTION OF CHIP VIEW WINDOW

After completing the steps in the Software Installation Procedures
section and the Evaluation Board Setup Procedures section, set
up the system for data capture by taking the following steps:
1. Block icons that are dark blue are programmable blocks.
Click a dark blue block icon to open a configurable pop-up
window to customize the data capture. Figure 15 shows the
Over Sampling configurable pop-up window.
2. Click the REF block in Figure 16 to access the Reference
Voltage configurable pop-up window, and select External
from the Reference Voltage dropdown menu. The default
value for the external reference is set to 3.3 V and 2.5 V for
the internal reference.
AD7383 (see Figure 14).