ECOTEST TERRA-P MKS-05 Operating Manual page 39

6.3.6 Indication and correction of real time
Press shortly the MODE button to initiate the mode of real time indication. This
mode follows the mode of indication of gamma radiation DE measurement value.
It is indicated by a one-second blinking double point between the two pairs of the LCD
digits.
The digits from the right to the left show the following: the first digit indicates minutes;
the second one - tens of minutes; the third one - hours; the fourth one - tens of hours.
Press the THRESHOLD button and hold it pressed until two digits to the right
from double point start blinking to correct the value of real time, and then release the
button. The proper values of units and tens of minutes are fixed by further pressing
and holding the THRESHOLD button. Press shortly the THRESHOLD button to
correct the value of minutes. Each pressing will change the value per unit. Press
shortly the MODE button to correct the value of hours. Two digits on the left of
double point start blinking at that. The hour value correction is performed likewise.
Press shortly the MODE button once again to exit the mode of real time correction.
39