Collimator Centering; Servo State Mode; Hospital Manual - Canon OMNERA 400A Operator's Manual

User Interface
Overhead Tube Crane

3.1.8 Collimator Centering

The collimator centering is adjusted by pressing the Collimator centering button.
A pop-up window according to Fig. 3-12 Collimator centering selection, will appear with the
alternatives Top centering, and Bottom centering. Select the desired collimator centering.
The pop-up window will automatically close shortly after the selection, and the light field will
adjust accordingly.
Collimator centering selection 1) Top, 2) Center and 3) Bottom

3.1.9 Servo State Mode

Fig. 3-13 Servo state mode
1. Automatic mode
2. Manual mode

3.1.10 Hospital manual

The hospital manual is reached by a activating the Hospital manual button for 1 second.
OMNERA®
1
Fig. 3-12 Collimator centering selection
1
2
Fig. 3-14 Hospital manual button
0073-095-418-EN Rev. 5.1
2 3
The Servo state can be either Automatic
mode (1) or Manual mode (2).
A pop-up window according to Fig. 3-13
Servo state mode, will appear with two al-
ternatives. When the System is in Manual
mode all movements are allowed and expo-
sure can be performed in any position, also
outside the detector.
For further information about Manual mode,
see corresponding section.
Page 44
Operator´s Manual
2020-09-25